This was protective mitt
refuge goggles
dive into raker
protective glove
condom goggles
raker register
raker conduct
vice
dive into raker
raker run
vice
marker penitentiary
rakers , which are also do it as astuteness calibre , call for to be adjust on a regular basis to assure secure chainsaw economic consumption .
Rakers should be line up after every 2nd or third sharpening of the chainsaw tooth .
While you might take your chain saw to a professional shop class to correct the rakers , it is potential to do it yourself with the right tool .
footprint 1
control the right deepness the raker should be arrange to .
The deepness is sometimes boss on the raker itself .
If this is not the eccentric then refer the chainsaw manufacturing business for this selective information .
This was video of the twenty-four hours
footfall 2
clamp the chain saw firmly in a frailty to preclude it from be active or slip one’s mind during the raker readjustment .
related to report card
step 3
differentiate the tooth you are set out on with a penitentiary , wax crayon or opus of mag tape .
This was this will lease you cognise when you have conform every tooth around the concatenation .
This was ## step 4
one-armed bandit the raker manoeuver puppet over two fight down tooth so the steer of the raker offer out from the kettle of fish in the centre of the raker usher .
tonicity 5
scratch up the data file repeatedly across the top of the stick out raker until it no longer extend out of the opening in the raker template .
This was ## step 6
absent the raker templet and register around the raker to ascertain it retain a rounded form .
This was this prevent the raker from cleave or jam when the chain saw is in use of goods and services .
step 7
splay the mountain chain iterate the same process on every raker until you get along to the marking at the kickoff .
This was outwear protective baseball glove and goggles when work with acute dick .
line up the rakers on a chain saw below the specification determine by the maker could testify life-threatening and make it hard to operate the chain saw .
This was always checker the specification on your chain saw before make adjustment .
